![]() Despite the different names, they all do essentially the same thing: generate more frames in between the already existing frames, for super-smooth motion. ![]() It goes by "Motionflow" on Sony TVs, "Motion Rate Supreme" or "Auto Motion Plus" on Samsung TVs, "TruMotion" on LG TVs and "Smooth Motion Effect" on Vizio TVs. Motion Interpolation: Every manufacturer has its own name for this. That said, you may want to turn them on for old DVDs (or even cable TV, if you find that it looks better). For high-quality content, like Blu-rays, these are best left off, since they can soften the picture. Super Resolution, Reality Creation, Smooth Gradation and other Noise Reduction features: These attempt to make low-quality content look better, sharpening the picture and removing noise and other artifacts caused by digital compression or analog conversion. You should leave that set to the Movie mode's default, usually "warm.") (Note that "Color Temperature" should not be lumped in with these features. But if the movie you're watching was properly mastered, the color should be fine turn these off for the most natural-looking image. Live Color makes colors more saturated, HDR+ Mode attempts to make standard content look more like HDR, and Flesh Tone attempts to make skin pop. ![]() Live Color, HDR+ Mode and Flesh Tone: All of these features introduce post-processing designed to enhance the color in some way. That sounds good, but oversharpening can also create artifacts, like a "halo effect" around edges. You might think that's a good thing, but in fact, it just causes the opposite problem: By lightening dark areas, you're more likely to introduce artifacts.Įdge Enhancement: This feature attempts to make the image look a little sharper. It's best to leave this off.īlack Detail: This is the opposite of Black Tone - it attempts to enhance details in dark areas by brightening them. Instead, this will make dark gray areas black, which will cause you to lose detail. Turn this off and you'll ensure you're getting the maximum amount of detail in the picture.īlack Tone: Similar to Dynamic Contrast, this attempts to make black areas look darker - but you can't actually make your TV's blacks blacker than they already are. It can also introduce color banding artifacts. That may make the picture "pop" a bit more, but in doing so, it'll often crush blacks and whites, reducing the detail of the scene. Note that these recommendations apply to both standard and HDR TVs.ĭynamic Contrast: Sometimes called "Contrast Enhance," this makes dark areas darker and bright areas brighter. In some cases, choosing that "Movie" picture mode may disable some of the below settings automatically - but it's still a good idea to scour the settings menu yourself. This will ensure that your basic brightness, contrast and color settings are as close to accurate as possible - at least, without going through a time-consuming calibration.Īfter that, you'll want to head to the advanced picture menus to disable your TV's post-processing features. Before you start tweaking, set the display's mode to "Movie" (this is sometimes called "Cinema," "Expert" or "Custom"). ![]() ![]() Jump into your TV's settings and head to the picture settings menu. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |